Share:


Experimental study of carriageway operational condition influence on acoustic roadside area pollution

    Evgenija Ugnenko Affiliation
    ; Vadim Gavrish Affiliation
    ; Gintas Viselga Affiliation
    ; Giedrius Garbinčius Affiliation
    ; Vytautas Turla Affiliation
    ; Saulius Nagurnas Affiliation

Abstract

Environmental noise management is an important part of the policy across the EU policy context, because transportation noise is a significant local environmental problem for most of the urban population. Increasing numbers of vehicles are associated with growing noise levels from road transport in urban areas and rising public health problems. Motor transport is considered to be a main source of noise pollution, so it is important to investigate the level of traffic noise and assess the relationship with traffic flows. The paper describes the main methods for determination of noise characteristics of traffic flows. The dependences for the prediction of the equivalent noise level and the results of field measurements of sound levels are presented. The results of field experiments and the calculated values of sound levels obtained by the analytical method are tested for homogeneity, using the Wilcoxon test. Experimental studies have established that the external sound level depends largely on the speed of vehicles, road conditions, and basic operating characteristics of highways. The analytical method associated with the use of deterministic and probabilistic models makes it possible to predict the traffic noise. But when dealing with the foregoing methods, there arise specific problems, many of which have not been resolved: there is no uniform terminology, nor is there any consensus on the use of noise characteristics of traffic flows in calculations at different stages of construction and reconstruction of highways of a certain traffic flow model under conditions of human settlements. Standardized measurement methods have been established and revised throughout the years by many renowned researchers. These methodologies have been revised in order to minimize problems that may occur and may not be foreseen by a less experienced researcher when adopting the measurement methods. Standardizing the measurement method is also useful for researchers because it becomes possible for researchers from around the world to compare their data. The joint effect of road conditions and the operational status of the roadway on the acoustic pollution of the roadside area is not fully taken into account. Therefore, applying the internationally recognized acoustical measurement standards is a good way to start any noise measurement experiment. The purpose of experimental research is to investigate the joint effect of road conditions and the operational status of the roadway on the acoustic pollution of the roadside area of settlements: identify the main characteristics of noise produced by traffic flows, consider the comparability of results of the field experiment and analytical computations. Slopes of 20…40‰ have little impact on the noise caused by the movement of passenger cars and trucks. In this case, the average acoustic emissions are identical to those used in the prediction of noise mode.

Keyword : noise, acoustic emission, equivalent noise level, road, traffic, roadside area

How to Cite
Ugnenko, E., Gavrish, V., Viselga, G., Garbinčius, G., Turla, V., & Nagurnas, S. (2019). Experimental study of carriageway operational condition influence on acoustic roadside area pollution. Transport, 34(5), 591-599. https://doi.org/10.3846/transport.2019.11709
Published in Issue
Dec 18, 2019
Abstract Views
711
PDF Downloads
185
Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

References

Bikuvienė, I.; Juodkienė, V. 2017. Simulation and analysis of car noise pollution in the territory of Kaunas university of applied sciences, in Sinteza 2017: International Scientific Conference on Information Technology and Data Related Research: Book of Proceedings, 21 April 2017, Belgrade, Serbia, 291–296. https://doi.org/10.15308/Sinteza-2017-291-296

Den Boer, L. C.; Schroten, A. 2007. Traffic Noise Reduction in Europe: Health Effects, Social Costs and Technical and Policy Options to Reduce Road and Rail Traffic Noise. CE Delft, The Netherlands. 70 p. Available from Internet: https://www.ce-delft.eu/publicatie/traffic_noise_reduction_in_europe/821

EEA. 2014. Noise in Europe 2014. European Environment Agency (EEA) Report No 10/2014. Copenhagen, Denmark. 68 p. Available from Internet: https://doi.org/10.2800/763331

GOST 31330.1:2006. Shum. Ocenka vliyaniya dorozhnogo pokrytiya na transportnyj shum. Chast’ 1. Statisticheskij metod [Noise. Measurement of the influence of road surfaces on traffic noise. Part 1. Statistical method]. (in Russian).

Ho, K.-Y.; Hung, W.-T.; Ng, C.-F.; Lam, Y.-K.; Leung, R.; Kam, E. 2013. The effects of road surface and tyre deterioration on tyre/road noise emission, Applied Acoustics 74(7): 921–925. https://doi.org/10.1016/j.apacoust.2013.01.010

IEC 60942:2017. Electroacoustics – Sound Calibrators.

Ilgakojis, P.; Jotautiene, E.; Merkevicius, S.; Bazaras, J. 2005. An investigation of infrasonic in traffic flow noise, WIT Transactions on The Built Environment 77: 511–520.

ISO 11819-1:1997. Acoustics – Measurement of the Influence of Road Surfaces on Traffic Noise – Part 1: Statistical Pass-By Method.

ISO 11819-2:2017. Acoustics – Measurement of the Influence of Road Surfaces on Traffic Noise – Part 2: The Close-Proximity Method.

ISO/TC 43. Acoustics.

Masino, J.; Pinay, J.; Reischl, M.; Gauterin, F. 2017. Road surface prediction from acoustical measurements in the tire cavity using support vector machine, Applied Acoustics 125: 41–48. https://doi.org/10.1016/j.apacoust.2017.03.018

Miškinytė, A.; Dėdelė, A. 2014. Evaluation and analysis of traffic noise level in Kaunas city, in 9th International Conference on Environmental Engineering: Selected Papers, 22–23 May 2014, Vilnius, Lithuania, 1–6. https://doi.org/10.3846/enviro.2014.036

Mohamed, Z.; Wang, X. 2016. A deterministic and statistical energy analysis of tyre cavity resonance noise, Mechanical Systems and Signal Processing 70–71: 947–957. https://doi.org/10.1016/j.ymssp.2015.09.012

Moon, H. R.; Kang, W. P.; Lim, Y. J. 2013. Development and basic experiment of active noise control system for reduction of road noise, International Journal of Highway Engineering 15(6): 41–47. https://doi.org/10.7855/IJHE.2013.15.6.041 (in Korean).

Morgan, P. (Ed.). 2006. Guidance Manual for the Implementation of Low-Noise Road Surfaces. Forum of European National Highway Research Laboratories (FEHRL) Report No 2006/2. Brussels, Belgium. 332 p.

Nucara, A.; Pietrafesa, M.; Scaccianoce, G.; Staltari, G. 2001. A comparison between analytical models and artificial neural networks in the evaluation of traffic noise levels, in Proceedings of the 17th International Congress on Acoustics, 2–7 September 2001, Rome, Italy, 208–209.

Parnell, J.; Samuels, S. 2006. A comparison of tyre/road noise generated on NSW pavements to international studies, in Proceedings of Acoustics 2006: Noise of Progress, 20–22 November 2006, Christchurch, New Zealand, 369–375.

Samuels, S.; Parnell, J. 2001. Some recent Australian developments in the reduction of road pavement noise, in Australian Acoustical Society Annual Conference: Acoustics 2001: Noise and Vibration Policy – the Way Forward?, 21–23 November 2001, Canberra, Australia, A3.2/1–A3.2/12.

Sandberg, U.; Ejsmont, J. A. 2002. Tyre/Road Noise Reference Book. Informex. 640 p.

Sandberg, U.; Glaeser, K.-P. 2008. Effect of tyre wear on noise emission and rolling resistance, in 37th International Congress and Exhibition on Noise Control Engineering 2008 (Inter-Noise 2008), 26–29 October 2008, Shanghai, China, 5241–5260.

Smolnikovas, M.; Viselga, G.; Viselgaitė, G.; Jasinskas, A. 2015. Dyzelinių variklių su įvairiomis įpurškimo sistemomis išmetamųjų dujų tyrimas [Diesel engine with different kind of injection systems exhaust gas analysis], Mokslas – Lietuvos ateitis [Science – Future of Lithuania] 7(5): 594–600. https://doi.org/10.3846/mla.2015.841 (in Lithuanian).

Tanaka, Y.; Horikawa, S.; Murata, S. 2016. An evaluation method for measuring SPL and mode shape of tire cavity resonance by using multi-microphone system, Applied Acoustics 105: 171–178. https://doi.org/10.1016/j.apacoust.2015.12.009

Ugnenko, E. B. 2008. Metodologiya proektirovaniya rekonstrukcii avtomobil’nyh dorog s uchetom jekologicheskih pokazatelej: Monografiya. Har’kov: HNADU. 184 s. (in Russian).

Ugnenko, E.; Perova, E.; Voronova, Y.; Viselga, G. 2017. Improvement of the mathematical model for determining the length of the runway at the stage of aircraft landing, Procedia Engineering 187: 733–741. https://doi.org/10.1016/j.proeng.2017.04.448

WHO. 2018. Noise: Data and Statistics. World Health Organization (WHO), Regional Office for Europe, Copenhagen, Denmark. Available from Internet: http://www.euro.who.int/en/health-topics/environment-and-health/noise/data-and-statistics